182 research outputs found
Recommended from our members
Oxidation resistant coatings for ceramic matrix composite components
Corrosion resistant Ca{sub 0.6}Mg{sub 0.4}Zr{sub 4}(PO{sub 4}){sub 6} (CMZP) and Ca{sub 0.5}Sr{sub 0.5}Zr{sub 4}(PO{sub 4}){sub 6} (CS-50) coatings for fiber-reinforced SiC-matrix composite heat exchanger tubes have been developed. Aqueous slurries of both oxides were prepared with high solids loading. One coating process consisted of dipping the samples in a slip. A tape casting process has also been created that produced relatively thin and dense coatings covering a large area. A processing technique was developed, utilizing a pre-sintering step, which produced coatings with minimal cracking
Recommended from our members
Design and Initial Development of Monolithic Cross-Flow Ceramic Hot-Gas Filters
Advanced, coal-fueled, power generation systems utilizing pressurized fluidized bed combustion (PFBC) and integrated gasification combined cycle (IGCC) technologies are currently being developed for high-efficiency, low emissions, and low-cost power generation. In spite of the advantages of these promising technologies, the severe operating environment often leads to material degradation and loss of performance in the barrier filters used for particle entrapment. To address this problem, LoTEC Inc., and Oak Ridge National Laboratory are jointly designing and developing a monolithic cross-flow ceramic hot-gas filter. The filter concept involves a truly monolithic cross-flow design that is resistant to delamination, can be easily fabricated, and offers flexibility of geometry and material make-up. During Phase I of the program, a thermo-mechanical analysis was performed to determine how a cross-flow filter would respond both thermally and mechanically to a series of thermal and mechanical loads. The cross-flow filter mold was designed accordingly, and the materials selection was narrowed down to Ca{sub 0.5}Sr{sub 0.5}Zr{sub 4}P{sub 6}O{sub 24} (CS-50) and 2Al{sub 2}O{sub 3}-3SiO{sub 2} (mullite). A fabrication process was developed using gelcasting technology and monolithic cross-flow filters were fabricated. The program focuses on obtaining optimum filter permeability and testing the corrosion resistance of the candidate materials
Recommended from our members
Fiber-matrix interfaces in ceramic composites
The mechanical properties of ceramic matrix composites (CMCs) are governed by the relationships between the matrix, the interface material, and the fibers. In non-oxide matrix systems compliant pyrolytic carbon and BN have been demonstrated to be effective interface materials, allowing for absorption of mismatch stresses between fiber and matrix and offering a poorly bonded interface for crack deflection. The resulting materials have demonstrated remarkable strain/damage tolerance together with high strength. Carbon or BN, however, suffer from oxidative loss in many service environments, and thus there is a major search for oxidation resistant alternatives. This paper reviews the issues related to developing a stable and effective interface material for non-oxide matrix CMCs
Recommended from our members
Oxidation-resistant interfacial coatings for continuous fiber ceramic composites
Developing an oxidation-resistant interfacial coating for continuous fiber ceramic composites (CFCCs) continues to be a major challenge. CFCCs` mechanical behavior are influenced by the interfacial bonding characteristics between the fiber and the matrix. Finite element modeling studies suggest that a low-modulus interfacial coating material will be effective in reducing the residual thermal stresses that are generated upon cooling from processing temperatures. Nicalon/SiC composites with carbon, alumina and mullite interfacial coatings were fabricated with the SiC matrix deposited using a forced-flow chemical vapor infiltration process. Composites with mullite interfacial coatings exhibited considerable fiber pull-out even after oxidation and have potential as a composite system
Inhomogeneous nucleation in quark hadron phase transition
The effect of subcritical hadron bubbles on a first-order quark-hadron phase
transition is studied. These subcritical hadron bubbles are created due to
thermal fluctuations, and can introduce a finite amount of phase mixing (quark
phase mixed with hadron phase) even at and above the critical temperature. For
reasonable choices of surface tension and correlation length, as obtained from
the lattice QCD calculations, we show that the amount of phase mixing at the
critical temperature remains below the percolation threshold. Thus, as the
system cools below the critical temperature, the transition proceeds through
the nucleation of critical-size hadron bubbles from a metastable quark-gluon
phase (QGP), within an inhomogeneous background populated by an equilibrium
distribution of subcritical hadron bubbles. The inhomogeneity of the medium
results in a substantial reduction of the nucleation barrier for critical
bubbles. Using the corrected nucleation barrier, we estimate the amount of
supercooling for different parameters controlling the phase transition, and
briefly discuss its implications to cosmology and heavy-ion collisions.Comment: LaTeX, 14 pages with 8 Postscript figures. Discussion added in
introduction and conclusion, Fig. 8 added, few more references added,
Typographical errors corrected. Version to appear in Phys. Rev.
Estructura agraria y dinámica de pobreza rural en el Perú
A partir de un panel provincial para el periodo entre los censos agropecuarios de 1994 y el 2012, este estudio pretende esclarecer el signo de la relación entre estructura agraria y dinámicas de pobreza rural en el Perú. Los resultados descriptivos revelan que las provincias con reducciones importantes en las tasas de pobreza rural son aquellas cuyas unidades agropecuarias tenían, al inicio del periodo, una mayor cantidad de tierra agrícola - en equivalente de riego -, una estructura de propiedad menos fragmentada, una distribución de la tierra más equitativa y una mayor proporción de productores con capacidad de innovación tecnológica. Por otro lado, los resultados econométricos sugieren que un importante determinante de la dinámica de pobreza rural observada es el tamaño de la propiedad, y no la estructura agraria. Asimismo, se muestra que las provincias cuya tasa de emigración es más alta y cuya tasa de inmigración es más baja son las que sufren un mayor aumento de la pobreza rural. Por último, junto con variables que pueden estar determinando un acceso diferenciado a los mercados, persiste un impacto positivo del grado de diversificación de la actividad productiva sobre las posibilidades de generar dinámicas de reducción de la pobreza en áreas rurales
Where’s WALY? : A proof of concept study of the ‘wellbeing adjusted life year’ using secondary analysis of cross-sectional survey data
Background
The Quality-Adjusted Life Year (QALY) is a measure that combines life extension and health improvement in a single score, reflecting preferences around different types of health gain. It can therefore be used to inform decision-making around allocation of health care resources to mutually exclusive options that would produce qualitatively different health benefits. A number of quality-of-life instruments can be used to calculate QALYs. The EQ-5D is one of the most commonly used, and is the preferred option for submissions to NICE (https://www.nice.org.uk/process/pmg9/). However, it has limitations that might make it unsuitable for use in areas such as public and mental health where interventions may aim to improve well-being. One alternative to the QALY is a Wellbeing-Adjusted Life Year. In this study we explore the need for a Wellbeing-Adjusted Life Year measure by examining the extent to which a measure of wellbeing (the Warwick-Edinburgh Mental Well-being Scale) maps onto the EQ-5D-3L.
Methods
Secondary analyses were conducted on data from the Coventry Household Survey in which 7469 participants completed the EQ-5D-3L, Warwick-Edinburgh Mental Well-being Scale, and a measure of self-rated health. Data were analysed using descriptive statistics, Pearson’s and Spearman’s correlations, linear regression, and receiver operating characteristic curves.
Results
Approximately 75 % of participants scored the maximum on the EQ-5D-3L. Those with maximum EQ-5D-3L scores reported a wide range of levels of mental wellbeing. Both the Warwick-Edinburgh Mental Well-being Scale and the EQ-5D-3L were able to detect differences between those with higher and lower levels of self-reported health. Linear regression indicated that scores on the Warwick-Edinburgh Mental Well-being Scale and the EQ-5D-3L were weakly, positively correlated (with R2 being 0.104 for the index and 0.141 for the visual analogue scale).
Conclusion
The Warwick-Edinburgh Mental Well-being Scale maps onto the EQ-5D-3L to only a limited extent. Levels of mental wellbeing varied greatly amongst participants who had the maximum score on the EQ-5D-3L. To evaluate the relative effectiveness of interventions that impact on mental wellbeing, a new measure – a Wellbeing Adjusted Life Year – is needed
A multimeasure approach to investigating affective appraisal of social information in Williams syndrome
People with Williams syndrome (WS) have been consistently described as showing heightened sociability, gregariousness, and interest in people, in conjunction with an uneven cognitive profile and mild to moderate intellectual or learning disability. To explore the mechanisms underlying this unusual social–behavioral phenotype, we investigated whether individuals with WS show an atypical appraisal style and autonomic responsiveness to emotionally laden images with social or nonsocial content. Adolescents and adults with WS were compared to chronological age-matched and nonverbal mental age-matched groups in their responses to positive and negative images with or without social content, using measures of self-selected viewing time (SSVT), autonomic arousal reflected in pupil dilation measures, and likeability ratings. The participants with WS looked significantly longer at the social images compared to images without social content and had reduced arousal to the negative social images compared to the control groups. In contrast to the comparison groups, the explicit ratings of likeability in the WS group did not correlate with their SSVT; instead, they reflected an appraisal style of more extreme ratings. This distinctive pattern of viewing interest, likeability ratings, and autonomic arousal to images with social content in the WS group suggests that their heightened social drive may be related to atypical functioning of reward-related brain systems reflected in SSVT and autonomic reactivity measures, but not in explicit ratings
Anxiety Disorders in Williams Syndrome Contrasted with Intellectual Disability and the General Population: A Systematic Review and Meta-Analysis
Individuals with specific genetic syndromes associated with intellectual disability (ID), such as Williams syndrome (WS), are at increased risk for developing anxiety disorders. A systematic literature review identified sixteen WS papers that could generate pooled prevalence estimates of anxiety disorders for WS. A meta-analysis compared these estimates with prevalence estimates for the heterogeneous ID population and the general population. Estimated rates of anxiety disorders in WS were high. WS individuals were four times more likely to experience anxiety than individuals with ID, and the risk was also heightened compared to the general population. The results provide further evidence of an unusual profile of high anxiety in WS
- …